Grease Monkeys NZ

A Site for Garage Built Custom Motorcycles with that Vintage Vibe
 
HomeHome  FAQFAQ  SearchSearch  MemberlistMemberlist  UsergroupsUsergroups  RegisterRegister  Log inLog in  

Share | 
 

 indicator issue

View previous topic View next topic Go down 
AuthorMessage
Road-Rasher



Posts : 14
Join date : 2011-08-31
Age : 31
Location : Auckland

PostSubject: indicator issue   Thu Mar 06, 2014 7:34 am

Hi guys ive got a bit of a problem on my 98 vn1500,
My rh indicator is throwing a spaz, it starts off normal flash rate after a few flashes it goes fast as if a bulb is out. But both front and rear are flashing.
Lh side is fine. Any suggestions would be greatly appreciated. Or if ya keen to help I could bring the bike and beer anywhere in Auckland. Im sure its just a small problem ive overlooked.

Cheers.
Back to top Go down
View user profile
Irishjon
Admin


Posts : 1360
Join date : 2009-11-04
Age : 60
Location : Auckland

PostSubject: Re: indicator issue   Thu Mar 06, 2014 8:19 am

I had the same problem and it was a resistance issue. I was using indicators with two fillaments. Connected them both together and problem went away. You might need to add an inline resistor. Scotty can probably tell you the right size.

_________________
IRISHJON
Serial Bike Abuser
Back to top Go down
View user profile http://www.greasemonkeys.co.nz
Road-Rasher



Posts : 14
Join date : 2011-08-31
Age : 31
Location : Auckland

PostSubject: Re: indicator issue   Thu Mar 06, 2014 6:11 pm

Cheers. Il check the bulbs otherwise il look up Scotty.
Thanks.
Back to top Go down
View user profile
Sponsored content




PostSubject: Re: indicator issue   Today at 7:39 am

Back to top Go down
 
indicator issue
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Ironstone is it an indicator?
» Gear indicator
» Tour Issue Equipment
» Help! R9 screw issue
» Danica Patrick SI Swimsuit Issue

Permissions in this forum:You cannot reply to topics in this forum
Grease Monkeys NZ :: The Build Files :: Build help required-
Jump to: